2.3 g 32 cavities spoon mould
2.3 g 32 cavities spoon mould made by USEE PLASTIC MOULD CO.,LTD
spoon weight: 2.3 g
cavities number: 32
material: PP
mould steel: core & cavity use H13 good level, mould base use P20
one point centre hot runner
this spoon mould we tested only one time, we found flaw very carefully but can not find out.
in case some flaw we lost, then we tested again but still did not find out any flaw.
this spoon mould customer machine is 358 T high speed machine, so we test mould on 300 T high speed machine.
cycle time is about 6-8S.
this spoon mould water cold effection is very good, because we use copper make the runner.
USEE PLASTIC MOULD CO.,LTD, is a professional plastic cutlery mould maker in china.
we make many spoon mould, fork mould, knife mould, thin-wall container mould
for more information, welcome to contact us
ella@useemould.com
Mob/whatsapp/wechat: 0086 18806571259
www.useemould.com
www.cutlery-mould.com
